Residential Mould Cleaning Adelaide
The professional team at Master Class Cleaning Group Adelaide are IICRC accredited mould removal experts and have more than 20 years mould remediation experience. Over this time, we have successfully cleaned and remediated mould in literally thousands of properties throughout Adelaide. Our team can offer you safe, permanent and effective solutions to your ongoing mould issues in Adelaide. Mould can be a health hazard so if you have any concerns, call our team straight away and we can inspect and assess your situation.
Why us for your mould cleaning Adelaide
- We are IICRC Industry accredited mould remediation experts
- We have over 20 years mould cleaning experience
- We deliver safe and permanent mould remediation solutions
- We adhere strictly to the IICRC mould remediation standards
- Our mould removal services have been trusted by major insurers for many years
- We deliver prompt, professional, mould remediation services Adelaide wide
- We take the time required to ensure the job is done properly
Common causes of mould
- Unattended water damage events
- Old water damage that was not correctly remediated
- Leaking tapes and pipes that have not been rectified
- Ongoing roof and gutter leaks
- Properties with poor ventilation
- Exhaust fans that are not working correctly
- Poor drainage around the outside of the property
- Rising damp issues
- Environmental reasons such as raised moisture and high humidity
Common materials mould grows on
Some common materials that mould will grow on especially after a flood or water damage event include.
- Wet carpets and underlay
- Gyprock walls, ceilings and cornices
- Curtains and blinds
- Fabric furniture and furnishings
- Mattresses and ensembles
- Timber wall frames inside wall cavities
- Wall and ceiling insulation
- Brick and masonry walls
- Timber and concrete sub-floors
- Underneath kitchen cabinetry
- Underneath bathroom and laundry vanities
Once mould takes hold it can continue to grow at a rapid rate this is why it’s always best to act fast and seek professional advice as soon as you notice any signs of mould within your property.
Our Mould cleaning Adelaide process
STEP 1 – Inspection – We thoroughly inspect the affected areas to identify the full extent of the mould contamination.
STEP 2 – Containment – Before we begin work, we contain the affected areas to stop the spread of mould and to ensure the safety of all parties involved.
STEP 3 – Protection – Hepa filters are installed to trap any mould spores and to create a negative air pressure within the containment.
STEP 4 – Mould Removal – This is where we apply our specialised anti-bacterial treatments and provide the cleaning process. In some cases, some of the mould affected materials may need to be removed.
STEP 5 – Structural Drying- Now that the mould has been cleaned and remediated, we can carry out any structural drying of the water affected materials if required.
Mould cleaning Adelaide assessment
If you have a mould issue in your home or office space, call our team today for a thorough mould assessment. Once assessed our team can provide a scope of works for the required mould remediation works required. Don’t put up with toxic mould inside your property any longer we can deliver permanent solutions for your mould issues.
The sooner mould is removed the better
Whilst mould is present in your property it will continue to be a health hazard for you and your family. Mould will continue to grow and spread, and it will continue to do damage to the materials it is growing on. The longer the mould is left untreated the more difficult and more costly the remediation process will be. If you have mould in your property act now and phone our team straight away, the sooner we can begin the remediation process the better.
Our mould cleaning Adelaide services Include
- Installation of containments
- Hepa vacuuming
- Anti-bacterial cleaning
- Sanding of timber frames
- Air filtration with specialised air scrubbers
- Removal of contaminated materials if required
- Encapsulation of contaminated materials
- Structural drying of water affected materials
- Mould testing & mould clearances
Our full range of remediation services include
At Master Class Cleaning Group we provide a full range of professional water damage and mould remediation services Adelaide wide.
- Mould cleaning Adelaide
- Anti-bacterial cleaning & odour removal
- Sewage water clean-up and decontamination
- Water damage restoration
- 24/7 emergency water extraction Adelaide
- Flood & storm clean-up
- Structural drying
- Wet carpet drying
- Timber floor drying
- Specialised heat drying
Indoor air quality testing
Our team are experienced and equipped to provide professional indoor air testing for our clients. This is the best way to provide a reasonably accurate measure of the mould contamination within a mould affected property. We typically use two main methods to test the indoor air quality to determine the level of mould present.
Air testing with a specialised bio pump – Using this specialised apparatus of our team can take multiple air samples of the mould contaminated spaces. Once the mould spores are trapped within the Air-O-Cell cassettes that are contained within the Bio Pump we then send the cassettes off to the laboratory to be analysed. Whilst this method of testing can be quite costly the analysis is detailed and accurate. This form of mould testing will give an accurate indication of the full extent of the mould contamination.
Air testing with a particle count meter – Particle count meters provide a fast, convenient, and in-expensive alternative to testing the air for mould contamination. This method of mould testing is not as accurate as using a bio pump however it will still give a helpful indication of the mould levels within a contaminated space.
Mould surface testing
Mould will grow on all types of surfaces and in many cases is visible and can easily be identified. However, mould spores that are not visible will often settle on various types of surfaces throughout the affected areas and can also present health issues for the property occupants.
Bio tapes – These provide a sampling method for testing the mould. They are simply applied to the contaminated surface and then lifted off. The mould spores are then trapped on the stick surface of the tape and can then be sent to a lab for sampling.
Swabs – These are a simple method for testing for mould. The swab is simply rubbed over the affected surface trapping any mould spores on the tip of the cotton bud on the end of the swab. These swabs can then be sent to the lab for sampling.
Experienced mould cleaning experts
The team at Master Class Cleaning Group are IICRC accredited mould remediation experts. With more than 20 years Industry experience and knowledge you can certainly trust our professional team of mould remediation experts to take care of any mould issue that you may have. Using the latest mould remediation technologies and working strictly to the IICRC Industry standards and guidelines you can be assured that our team will deliver outstanding mould remediation results for you every time.